I would recommand removing the old OCX from the windows system32 folder and reinstall...
clicking has no use as there is no exit hotspot
BTW: Mercedes which OS are you using?
ShadowHunter wrote:Hi 3dgamer,
Like juhuwoorps already said, you have to apply to glue first or the pieces won't stick... I didn't want to make it too easy
I will check the error, it's probably a small scripting error from my side...consider it to be fixed by tomorrow.
It would save me some time though if you could describe exactlty what you did prior to the error.
Anyone else getting this error when the clock runs out?
@mercedes: the plugin is fully backwards compatible, just replace the OCX and PL1 file and you are good to go. If you have a registration key please enter it again in the new PL1 file.
With best regards,
Users browsing this forum: No registered users and 0 guests